I bought my first SSD more than 5 years ago (late 2007), for my white MacBook Core2Duo 2.0 Ghz. It may be needless to say that my MacBook ran faster than many MacBook Pro’s at that time. The look on peoples faces when they saw my MacBook boot faster than their MacBook Pro was unforgettable.

By that time I was also experimenting with running 2 x 8GB CompactFlash with SATA converters in RAID-0 mode in my completely silent (but old and under-clocked) Pentium 3 Linux desktop. When people would visit my home they couldn’t believe my PC was actually turned on: it was dead silent.

Even today I still enjoy building low-power, silent and ultra-fast (Linux) computers with an SSD as the primary drive. Nowadays the new mSATA standard (see picture) is being used. During the past years I learned a thing or two about configuring Linux on a SSD drive. Today I will share those things with you:

1) Buy more than enough RAM

Yep, you should have at least 16GB of RAM. I know you’ll say that you don’t use that, but that is exactly the point. If you would be using it, it would not be enough. And why not? RAM is relatively cheap these days and you don’t want your system to start swapping, since this will wear out your expensive SSD.

2) Use the default partition layout

Contrary to popular belief, the default (guided) partitioning will do. If you partition manually, keep in mind that you do need a swap partition that is bigger than your RAM size.

3) Avoid using swap

You have plenty of RAM, so you could turn off swap or even create a system without swap. I have been running without swap for a year or so and never experienced significant problems (other people say the same). The most annoying side-effect is that the hibernate function is not available, since it uses the swap partition. This is why I recommend to not completely disable swap, but to reduce the swappiness of Linux. This way Linux will use all available RAM before starting to write to your precious SSD, while still allowing you to hibernate. Still, be aware when it comes to using hibernate, because it uses a lot of writes. Run this one-liner to add a permanent swappiness setting:

This will only be effective after reboot.

4) Disable access time logging

Remove the access time logging on the file system. Without the “noatime” flag on your file system every read will cause a write, because the file system will update the access time. This is bad for the life-time of your SSD, since it supports a limited number of writes and this is causing significantly more writes. Edit the “fstab” to add the “noatime” flag:

Now change “errors=remount-ro” to “noatime,errors=remount-ro”. Save the file and reboot.

5) Enable TRIM

TRIM will stop your SSD from slowing down after using it for a while. If you do not enable TRIM the writes may become slower due to the erasing of the deleted blocks. By running this one-liner you can add TRIM as a daily cron job:

You have to make the cron job executable using:

It will be run every day to avoid slowing down your writes and you will hardly notice it.

More advice: monitor the expected life-time

Your disk will not run forever. It has an expected life-time and you should probably monitor it using:

This will output something like this:

At ID# 233 you see the MWI. This is a value starting at 100 and when it reaches values below 10 you should start to worry. Note that different manufacturers may have different names and numbers for this indicator.

Final advice: avoid buying TLC drives

Triple Level Cell (TLC) drives are making their entry in the market. These drives have a dramatically lower expected life-time. The life-time of a drive is measured in Program/Erase (PE) cycles or in Peta Bytes Written (PBW). Check the specs carefully to avoid buying a cheap drive, thinking you made a good deal, while actually buying a model with a lower expected life-time.

5 crucial optimizations for SSD usage in Ubuntu Linux