A standard technique for generating analog voltages using µCs is to use a PWM output and filter the signal with a simple RC filter (Figure 1). The voltage of the PWM signal is directly proportional to the µC‘s supply voltage, so it is not necessarily clean or stable. To overcome this problem, you can use the circuit in Figure 2. Here, a 74HC14 Schmitt-trigger array serves as an output stage for three PWM signals from an SX18 µC. (The idea applies to other µCs, too.) The 74HC14 derives its supply voltage, V_CCA, from the stabilization circuit comprising the inexpensive shunt regulator, SR₁. You can adjust V_CCA by trimming R₁. The test circuit used V_CCA=4.096V. The PWM signals now have a stable amplitude that varies less than 0.1% when the µC‘s supply varies from 4.5 to 5.5V. Resistors R₃ to R₅ limit the current flowing from the µC through the 74HC14‘s input-protection diodes when V_CCA is too low. The values of R and C depend on the application. The test circuit uses 10 kW and 4.7 µF. If you feed multiple analog (or PWM) signals through a single IC, you usually encounter crosstalk. To characterize the circuit in Figure 1 for internal crosstalk and unmatched delays, conduct the following tests.

Generated three PWM signals with different frequencies and 1-to-1 duty cycles. With a 0-dB reference-level square-wave signal at test point TP₁, crosstalk to test points TP₂and TP₃ measures –70 dB. The first harmonic of the PWM signal (theoretically zero for a 1-to-1 duty cycle) is down 65 dB at test point TP₁. At test point TP₀, spurs are down 75 dB. So, the circuit in Figure 1 has very good crosstalk characteristics. Also, if the duty cycle of one PWM channel changes, the influence on the voltage that other channels generates is less than 0.1%. You must take care to ensure that the switching delays of the 74HC14 do not change with varying V_CC applied to the µC. If the switching delays change with V_CC because of the changing levels of the driving signals, V_CC influences the generated output voltage, even if V_CCA is constant. You can use the circuit for precise generation of voltages, thanks to the temperature stability of the TL431. You can also use it for inexpensive implementations of sigma-delta converters, or to generate voltage-stabilized rectangular waveforms. (DI #2573)

Generate stabilized PWM signals